The installation process of the powder spraying line is as follows:

準備工作：準備好要噴涂的金屬材料，表面需經(jīng)過清潔處理，去除油污、銹蝕等雜質。同時，準備好專用的噴涂設備，如噴槍、噴粉機、烘干設備等，檢查設備的工作狀態(tài)，確保設備正常運行，噴涂效果良好。

Preparation work: Prepare the metal materials to be sprayed, and the surface needs to be cleaned to remove impurities such as oil stains and rust. At the same time, prepare specialized spraying equipment, such as spray guns, powder sprayers, drying equipment, etc., check the working status of the equipment to ensure its normal operation and good spraying effect.

將待噴粉的金屬制品放置在噴粉線上的傳送帶上，并調整傳送帶的速度和高度，以適應不同的工作需求。

Place the metal products to be sprayed onto the conveyor belt on the spraying line, and adjust the speed and height of the conveyor belt to meet different work needs.

打開設備的電源和氣源開關，確保設備正常運行。

Turn on the power and air switches of the equipment to ensure its normal operation.

調整噴嘴的位置和角度，使其能夠均勻地噴涂粉末在金屬制品表面上。

Adjust the position and angle of the nozzle to evenly spray powder onto the surface of the metal product.

通過調節(jié)噴粉槍上的控制按鈕或旋鈕，控制粉末的噴射量和噴射速度。

By adjusting the control button or knob on the powder spraying gun, the amount and speed of powder spraying can be controlled.